english 
Here are the steps to clean a gasoline tank:
- Prepare in advance: First, move the vehicle to a well - ventilated area away from any ignition sources. Then, use an approved fuel container to carefully empty the gasoline tank. Disconnect the negative terminal of the vehicle's battery to prevent any electrical sparks.
- Remove the tank: Depending on the vehicle model, remove the gasoline tank following the manufacturer's instructions. This usually involves loosening bolts, disconnecting fuel lines, and removing any brackets or straps that hold the tank in place. Be careful not to damage the surrounding components.
- Initial cleaning: Use a high - pressure air gun to blow out any loose dirt, debris, or rust particles from the inside of the tank. Then, pour a small amount of clean, non - flammable solvent, such as mineral spirits or acetone, into the tank. Tilt and rotate the tank to let the solvent wash the inner walls, dissolving any remaining fuel residues and grease.
- Brush cleaning: For stubborn dirt or rust, use a long - handled brush with soft bristles to scrub the inside of the tank. Pay special attention to the corners and seams where dirt is likely to accumulate. After brushing, pour out the solvent and dirt mixture.
- Rinse thoroughly: Rinse the tank several times with clean water to remove all traces of the solvent and dirt. Make sure to drain the water completely each time. You can also use compressed air to dry the tank interior to prevent rust.
-
Inspect and reinstall: Before reinstalling the tank, carefully inspect it for any signs of damage, such as cracks or holes. If any damage is found, it should be repaired or the tank replaced. Then, reinstall the tank in the vehicle, reconnect the fuel lines and other components, and tighten all the connections. Finally, reconnect the battery and perform a leak test to ensure the safety of the fuel system
